The blueprint docs had updated flashing instructions (enter bootloader, pyserial host dependency) which were missing in the machine docs. Sync them back.

Signed-off-by: Francesco Pham <francesco.pham@huawei.com>

This is no longer needed as we switched to a setup where we build bossac
with bitbake and use the internal version for flashing.

The result is a streamlined flashing experience where no extra
installation of the Arduino IDE and search for the PATH is needed
anymore.

Signed-off-by: Stefan Schmidt <stefan.schmidt@huawei.com>

Signed-off-by: Andrei Gherzan <andrei.gherzan@huawei.com>

* All project name replaced with tag
* definitions.rst reference added
* Closes: OSTC/OHOS/docs#77

Signed-off-by: Gururaj Shetty <gururaj.shetty@huawei.com>

Gururaj Shetty authored 3 years ago and Stefan Schmidt committed 3 years ago

Initially, Arudino did not enable USB CDC_ACM interface,
due to which once flashed, the user was forced to connect
an external USB TTL cable to connect the board.

This limitation is now resolved; hence, connecting USB
TTL cable information is removed.

Signed-off-by: Gururaj Shetty <gururaj.shetty@huawei.com>

    Add support for USB flash
    Converted note content to a sub section on install bossac
    This closes: OSTC/planning/hw-enablement#30

Signed-off-by: Gururaj Shetty <gururaj.shetty@huawei.com>

Davide Ricci authored 3 years ago and Stefan Schmidt committed 3 years ago

Signed-off-by: Davide Ricci <davide.ricci@huawei.com>

Details of the arduino-nano-33-ble.rst
How to flash
This closes OSTC/planning/hw-enablement#29

Signed-off-by: shettygururaj <gururaj.shetty@huawei.com>