Something went wrong on our end
-
Andrei Gherzan authoredThis change is in line with the project's rebranding. The collection is also changed a bit to drop the "meta-" prefix. There is no clear standardization on the collection name. Some use an ID, some use ID-layer, some use meta-ID etc. We have decided to use the the layer name without the "meta-" prefix because this is an ID, not a layer per se. Signed-off-by:
Andrei Gherzan <andrei.gherzan@huawei.com>Andrei Gherzan authoredThis change is in line with the project's rebranding. The collection is also changed a bit to drop the "meta-" prefix. There is no clear standardization on the collection name. Some use an ID, some use ID-layer, some use meta-ID etc. We have decided to use the the layer name without the "meta-" prefix because this is an ID, not a layer per se. Signed-off-by:Andrei Gherzan <andrei.gherzan@huawei.com>
Code owners
Assign users and groups as approvers for specific file changes. Learn more.
hostapd.conf 1018 B
# The Wi-Fi interface configured for static IPv4 addresses
# FIXME: the interface name used here is working in our current
# hardware setup for the blueprint, but we need to ensure it will work
# in all cases. Either by link renaming to ensure the correct
# interface name or by passing the correct interface in the service
# file to hostapd on the commandline.
interface=wlan0
# Use the 802.11 Netlink interface driver
driver=nl80211
# The user-defined name of the network
ssid=Oniro Project WiFi
# Use the 2.4GHz band
hw_mode=g
# Use channel 6
channel=6
# Enable 802.11n
ieee80211n=1
# Enable WMM
wmm_enabled=1
# Enable 40MHz channels with 20ns guard interval
ht_capab=[HT40][SHORT-GI-20][DSSS_CCK-40]
# Accept all MAC addresses
macaddr_acl=0
# Use WPA authentication
auth_algs=1
# Require clients to know the network name
ignore_broadcast_ssid=0
# Use WPA2
wpa=2
# Use a pre-shared key
wpa_key_mgmt=WPA-PSK
# The network passphrase
wpa_passphrase=12345678
# Use AES, instead of TKIP
rsn_pairwise=CCMP